archelaus's profile - activity

2019-08-29 03:56:36 -0600 received badge  Famous Question (source)
2019-08-22 10:48:53 -0600 received badge  Popular Question (source)
2019-07-16 06:36:50 -0600 received badge  Popular Question (source)
2019-07-13 16:37:12 -0600 received badge  Notable Question (source)
2019-07-13 16:37:12 -0600 received badge  Popular Question (source)
2019-07-11 06:52:04 -0600 asked a question Baremetal node inspect failed, version error

The exact error: Failed to start inspection: Version (1, 3) is not supported by the server, supported range is (1, 0) to (1, 0).

I tried specifying version as 1.0 in /etc/ironic/ironic.conf under [inspector] but still shows the same error.

Please ask if any files are needed.

2019-07-10 09:27:54 -0600 received badge  Student (source)
2019-07-10 08:49:10 -0600 asked a question ipmi sensor data from baremetal nodes

I can get sensor details via ipmi through ceilometry from control node but how do i get them from the baremetal nodes?

I have added a node and moved it to available state successfully, could anyone please tell me what i have to do to get the sensor data from nodes?

Please tell if any data is required.

2019-07-10 08:49:10 -0600 answered a question How do i get sensor details?

$ openstack metric list $ openstack metric measures show <id>

or via gnocchi

$ gnocchi metric list $ gnocchi measures show <id>

2019-07-10 00:12:35 -0600 received badge  Enthusiast
2019-07-09 05:22:47 -0600 asked a question PXE boot to login screen, when in cleaning state

I have followed the steps given in: (

When i added a fresh node and change its state from manageable to available it goes through cleaning step, on which the node goes to PXE boot but continues to login screen.

The state then goes to clean failed after a while with the error message:

Error: Detected change in error condition on node candle04. Timeout reached while cleaning the node. Please check if the ramdisk responsible for the cleaning is running on the node. Failed on step {}.

Please tell if i have to attach any files.


2019-07-05 02:28:11 -0600 commented question How do i get sensor details?

Thanks! I'll have a look

2019-07-04 17:27:17 -0600 asked a question How do i get sensor details?

i want to get sensor data from nodes, followed this to configure ironic settings - (

Now, what should i do (any command) to get these sensor details via openstack or ironic?

2019-07-01 06:36:03 -0600 asked a question [TripleO] undercloud install failed

Hi, I am using tripleo to install undercloud. I am getting the following error while doing so ("$ openstack undercloud install") : I ran the command again and i got this error:


Please suggest what do to , i'll attach any files if needed.