It's possible to modify some options for a specific instance in libvirt.xml file ?
I have tried to alter this file but when i start VM my custom settings was not applied.
Does anyone know why ?
Thanks
Salvo.
I had the same problem, you need to destroy and redifine your instance.
So, go into nova/instances/#INSTANCE ID#/libvirt.xml
Make your change.
Now run these commands:
(Open up the console on the VM to figure out the "XX"..)
virsh destroy instance-000000xx (No this will not terminate or remove your instance..Don't worry)
In OpenStack Dashboard, your VM will be POWERED OFF/SHUTDOWN. Simply do a soft reboot on it and it will re-sync.
Hello
I'm on Havana, and following those steps I was not able to save the changes.
To be clear I have added these lines to libvirt.xml
<serial type='tcp'>
<source mode='bind' host='127.0.0.1' service='2223'/>
<protocol type='telnet'/>
<target port='0'/>
<alias name='serial0'/>
</serial>
But after soft rebooting the instance from the Horizon GUI, those lines were not there anymore
Any suggestion ?
Hello guys
I followed step by step the above procedure, adding these lines to libvirt.xml
<serial type='tcp'>
<source mode='bind' host='127.0.0.1' service='2223'/>
<protocol type='telnet'/>
<target port='0'/>
<alias name='serial0'/>
</serial>
However after soft rebooting the instance from the Horizon GUI, those lines were not there anymore
Any suggestion ?
Asked: 2013-09-25 11:26:41 -0600
Seen: 9,283 times
Last updated: Apr 12 '14
